If the asbestos is in good condition a good paint job may look as good as the new vinyl siding.
Installing new siding over asbestos chingles.
A typical procedure is to install furring strips on the existing wall avoiding breaking the existing siding.
First the siding installation process itself nailing into the existing boards or tiles is enough to disturb the existing material and create a dangerous condition.
Measure the house for siding and the backer board.
Some people attempt to solve the problem of deteriorating asbestos siding by installing vinyl siding over top of it.
But be sure to check your local building codes first to see if it is allowed in your area.
Place the top edge of the plastic sheeting at the top of the exterior wall above the siding.
This practice is not recommended for a number of reasons.
As far as removing the asbestos and doing the job right i d make a story pole and see where the courses of the vinyl siding will fall.
Install the vapor.
The simplest way to do this is to use a tape measure to.
On the inside the wall construction is wallboard lath.
Firring out may not be nearly as much work as you might think.
Some experts recommend screwing rather than nailing when new siding is installed over existing asbestos cement siding.
Nail it in place using several nails a few inches apart until the top of the plastic is fully attached.
Inspect the outside of the home for any damages to the asbestos siding.
Although i do not recommend siding over existing siding i suppose a case could be made for doing so if you had an asbestos shingled house that was in great shape and you wanted to retain the fire retardant protection of the asbestos but still reside the house cheaply.
How to put siding on over asbestos step 1.
The plastic is used to create a barrier to the elements as well as prevents the siding from rubbing against the painted asbestos siding.
However removing the asbestos siding first though more expensive is the best alternative in the long run.
It is a stick build home with 1x5x3 4 sheathing covered with roofing felt and a single layer of asbestos shingles.
I am about to install vinyl siding siding over existing asbestos siding.
Make sure that there are no loose or.
Applying a layer of sheathing or sheets of foam insulation over the asbestos then covering it with vinyl siding is a common practice.
