Install Peel And Stick Roofing Underlayment

Peel and stick underlayment is stuck to the plywood with a strong adhesive on every square inch of the surface.

Install peel and stick roofing underlayment.

Peel and stick roll roofing is suitable for flat roof constructions. Once the adhesive has set it s very difficult to remove even intentionally. Peel and stick roof underlayment for metal roofs. Peel and stick underlayment is easier to install to start with plystik is easier to install than non adhesive underlayments.

There are several products to choose from such as tyvek protec 160 underlayment for metal roof grace tri flex xt underlayment for metal roof rhino underlayment for metal roof and titanium underlayment for metal roof. It then must extend up the roof deck at least 2 feet horizontal measure past the front wall of the house best measured from the interior wall surface outward. There is no nailing required which reduces labor and the rolls can be installed by one worker since the underlayment sticks to the roof deck as it s unrolled. In all but the most severe conditions it stays down.

In the above photo you can see the white backing that has been removed from the underlayment. Peel stick roofing underlayment top of the line premium heavy duty replacement for traditional peel and stick roofing underlayment epilay plystik plus is an extremely strong roofing underlayment with a 48 mil thickness and a 2 square roll weighing 48 lbs. Typically a flat roof is a low sloping roof with a maximum 10 degrees of pitch or usually having a slope of up to 3 inches per linear foot for adequate drainage. Installing peel and stick roll roofing on a flat roof requires a minimum slope of 1 2 inch per 12 inch roof run.

Peel and stick ice and water dam membrane is required in cold weather markets installing at roof eaves should be lapped under the drip edge and must cover the entire overhang.