Hand thread the screws then tighten them using a screwdriver or power drill.
How to install the 910 programmable door lock.
Attach the interior part of the deadbolt lock by inserting the two provided long screws through the interior plate the two screw holes in the bolt and into the exterior side of the lock.
Located on the interior side of the lock there are 4 switches.
Hold press and hold the lock button while installing battery pack l.
Program the lock install the battery cover and re key the lock programming instructions are located on the reverse side of this document.
Remove the existing deadbolt lock from the door.
This master lock video demonstrates how to install and operate the electronic programmable keypad deadbolt door locks.
Install the new deadbolt into the side of the door and test that the bolt.
Install the kwikset 910 z wave lock into your door.
Snap on the decorative outer plate.
B d 2x install strike aa x4 a b c l l ensure correct polarity.
Switch 2 if in the up position this will enable the 30 second auto locking feature and if the switch is in the down position this will disable the auto locking feature.
For best results use new non rechargeable alkaline batteries only.