How To Hang A Tarp On Wall

Tie a 6 foot piece of nylon rope to the grommet in the middle.

How to hang a tarp on wall.

Turn fabric into a work of art by stretching it over a wood frame or plywood board. I had planned to use toggle bolts to attach the 2 x10 x 20 or so on the length to the studs but the studs are in the wall the wrong way for me to drill thru and use the toggle s wing anchor. Step 2 drill a pilot hole into the stucco that s smaller than the size of the wall anchor screw. Cut an x at each mark with a utility knife making each cut 1 2 inch long.

Snip off the corners of each x to make holes in the tarp. Lay it on the ground then. Spread the tarp flat on the ground. Place a piece of scrap wood under the tarp where you made marks.

Stretch and fold the tapestry over the frame and attach with a staple gun. Make sure where you are going to hang your tarp. Step 3 hold the plastic sheeting against the wall approximately 1 inches below the ceiling. Cut the plastic sheet to the above measurements with a utility knife or scissors.

Bundle the rivets with the straps. Secure the tarp to the top pole using 6 inch ball bungee cords through the tarp grommets. Pull the tarp to the north of the east west line made by the two stakes until the ropes are taut. Use sawtooth picture hangers to mount.

Push the elastic end of the ball bungee through the grommet and pull it through until the hard ball stops. Adjust the length of the straps. I want to hang some shelves for the cats to travel and hang out on the wall out from under my feet and off the beds.